Jinyun Li Jie Machinery Manufacturing Co., Ltd. --- magnetic separator Preventive Maintenance random check if the plant noticed processing of ferrous metals increased (by observing the increase on the plated surface of the cured solder ball or other iron-containing slag particles to discover), on the device table record by recording meter readings at the pressure and flow and the cylinder body. Recommend to the factory in the meter reading is below the recommended lower parameter value, the wash basket. 1. Flow: 270 gpm (gallons / minute) 2. vessel internal pressure: 15 psi (pounds / square inch) If any value less than the recommended minimum value of time, according to the operating manual of instructions to check and clean the filter pipeline basket. According to the above, the flow rate and tank pressure can be adjusted by the return line (flow back into the process of recovery tank) on the valve calibration. Jinyun Li Jie Machinery Manufacturing Co., Ltd. --- magnetic separator safety instructions: 1. high pressure equipment may have a pressure vessel, so a single push plate feeder, for whatever reason before, during maintenance or open container Single Push plate feeder supply, make sure the pressure vessel is zero. 2. In the case of single-push pressure plate feeder manufacturer, hot liquid or (and) chemically active fluid leak can cause serious injury and blindness. 3. Do not exceed this container and seals use restrictions, under pressure of circumstances, never open the container. Liquid effluent can cause serious injury and blindness. Guangzhou single push plate feeder, Li Jie machinery, single push plate feeder supplied by Jinyun Li Jie Machinery Manufacturing Company Limited. Guangzhou single push plate feeder, Li Jie machinery, single push plate feeder supply is Jinyun Li Jie Machinery Manufacturing Co., Ltd. (www.jyljjx.net) this year introduced a new upgrade, the above picture is for reference only, please dial this page Phone or pictures on obtain the latest information, contact: Mr.